The sensor system is intended as a component for use e.g. in wind power plants to measure and evaluate vibrations in the mast head. Registration of dynamic accelerations by means of MEMS sensors (Micro-Electro-Mechanical System) with subsequent digitisation by a controller. The device consists of an acceleration sensors, a controller unit and three types of output interface. Data output is carried out via two analogue interfaces with 4 ... 20 mA plus CANopen and via 4 relay contacts (currently 1 error reИли отправьте нам запрос наrameterised via the CANopen interface. This is not galvanically separated. The sensor is equipped with a filter circuit to protect against fast transients and surge voltages of up to 2 kV in the supply. The protection types are IP 69K (housing) and IP 67 (connector/socket). With its good vibration and shock values, the sensor is suitable for use in areas with rough environmental conditions. The vibration sensor is equipped with a stable aluminium housing (optionally stainless steel). Elongated holes are available for mechanical alignment (up to approx. ± 7.5°). Electrical connection is carried out using two connectors or two cables.
Product category: | Vibration sensors |
Interface: | Analogue, CANopen, Relais |
Housing material: | Aluminium AIMgSi 1, Stainless steel 1.4305, Stainless steel 1.4404 |
Measuring ranges available for ordering: | ±2g |
Design: | 65mm |
Number of frequency ranges: | Please specify in the remark field. |
Number of relays: | 1, 2, 3, 4, 5 |
Number of analogue outputs: | Please specify in the remark field. |
Installation position: | Или отправьте нам запрос на TOP 5, TOP 6 |
Electrical connection: | Cable, Device connector M12 - connector/socket |
Output signal analogue: | 0 to 20 mA, 4 to 20 mA |
Device connector or cable: | 1 (fill in with cable only) |
Electrial and/or mechanical variant: | Standard |
8 (029) 555-8-000 | |
8 (044) 555-8-000 | |
8 (017) 255-8-000 |